If the label of the partition where linux is installed is mylinux, then boot it using rescuecd root=LABEL=mylinux. It's also possible to specify a partition using its filesystem label or filesystem uuid. So with root=auto let you start the system installed from the CD-ROM in case you have problem with your boot loader or kernel. The first linux system found will be started.
Support is also provided for root=auto, which scans all the block devices tfor a linux system. Use rescuecd root=/dev/VolGroup00/LogVol00. Keep in mind that you must use a 64bit kernel if your system is made of 64bit programs. For example, if you have linux Gentoo installed on /dev/sda6, use rescuecd root=/dev/sda6 to start it. root=/dev/xdnp: the root= option boots an existing linux system.This way you won't be prompted for the keyboard configuration during the boot. setkmap=kk: which defines the keymap to load where kk (example: setkmap=de for German keyboards).Add lowmem if you have less that 400MB of memory of to prevent these directories to be copied. This requires 400MB of memory to cache everything (including the bootdisks and isolinux directories). A slower start but once complete, programs start faster and the CD drive will be released allowing normal access to other CDs. docache: causes the CD-ROM will be fully loaded into memory.Press to add additional options (in SystemRescueCd-1.5 and more recent) Boot with this kernel in case you have problems with rescue64. altker64 an alternative kernel for 64bit systems.Boot with this kernel if you have problems with rescuecd altker32 an alternative kernel for 32bit systems.This kernel is able to boot with 32bit programs, and it requires a processor with 64bit instructions (amd64 / em64t).
#SYSTEMRESCUECD ISOLINUX RESCUE64 NOT FOUND 64 BITS#
Use it if you want to chroot to a 64bit linux system installed on your hard disk, or if you have to run 64 bits programs.
rescuecd Default for 32bit systems, with Framebuffer disabled, best choice.The kernel used is rescuecd, and anything after the word append is a boot parameter. Please see the page " Sysresccd-manual-en Booting the CD-ROM" You need to get info for a more recent version of SystemRescueCD The following info applies to SystemRescueCD v. When you are done, just press ENTER to boot. You must be careful not to change or remove the parameters that are dedicated to the CD itself, as altering them will certainty make it unbootable. They will be presented to you, and you can add or remove what you want. While in the splash screen of Clonezilla-SysRescCD, you can edit the boot parameters by pressing TAB. In our case, each CD (SystemRescueCD and Clonezilla Live) accept a different set of parameters, because they are based on gentoo and debian, respectively. These parameters, called boot parameters, are documented by the kernel itself, and can differentiate its behavior dramatically. The kernel is loaded by Isolinux (the CD boot manager), which is able to pass a number of parameters to it, through its configuration file isolinux.cfg. Well, this is not exactly true, and it is not the only thing that happens during boot up phase, but it is not my intension to explain it here. Booting a linux system means loading a kernel, which is actually the operating system.
0 kommentar(er)
